2 Mun Kae

发行方 Korea
年份 1678-1752
类型 Standard circulation coin
面值 2 Mun (0.002)
货币 Kingdom of Joseon - Mun (1633-1892)
材质 Copper
重量 8.5 g
直径 32 mm
厚度
形状 Round with a square hole
制作工艺
方向 Medal alignment ↑↑
雕刻师
流通至
参考资料 KM#806
正面描述 Chinese ideograms - Top to bottom: 常平 = Sang pyong, a Department of Korean Yi Dynasty - Right to left: 通寶 = Tong bo, means currency
正面文字
正面铭文  常 寶 通  平
背面描述 Mint mark at top, serial number at bottom. *開 (Kae): Kaesong Township Military Office
背面文字
背面铭文  開    二
(Translation: Kaesong Township Military Office, series 2)
边缘 Plain
铸币厂
铸造量 ND (1678-1752) 開 - -
Numisquare 编号 3529281670
附加信息

Historical Context: The 2 Mun Kae (KM#806), a copper coin from Korea, was issued between 1678 and 1752 during the Joseon Dynasty. Spanning the reigns of Kings Sukjong, Gyeongjong, and Yeongjo, its introduction was a crucial monetary reform. As part of the Sangpyeong Tongbo series, this larger denomination facilitated commercial transactions and addressed currency shortages, marking a significant step in developing a robust national currency system beyond barter. It underscored the dynasty's economic stabilization efforts.

Artistry: Joseon coinage adhered to a standardized, utilitarian stylistic school, emphasizing legibility over individual engraver artistry. The obverse typically features "Sangpyeong Tongbo" (常平通寶) and "Yi Mun" (二文) in clear kai-shu script, indicating its two-mun denomination. The reverse commonly displays a character for the issuing mint (e.g., "戸" for Hojo) and a numerical value "二" (two). The design reflects a pragmatic approach to currency, ensuring widespread recognition and trust in the monetary system.

Technical/Grading: As a cast copper coin, the 2 Mun Kae's high-points, prone to wear, are the central Hanja characters on both sides. Technical strike qualities vary, with superior examples showing sharp, distinct characters and minimal casting flaws like porosity or uneven edges. The planchet should be smooth, and the central square hole cleanly formed. Preservation of character detail and surface integrity is paramount for higher grades, as copper is susceptible to wear and environmental damage.

×