2 Mun Kae

Emitent Korea
Rok 1678-1752
Typ Standard circulation coin
Nominał 2 Mun (0.002)
Waluta Kingdom of Joseon - Mun (1633-1892)
Skład Copper
Waga 8.5 g
Średnica 32 mm
Grubość
Kształt Round with a square hole
Technika
Orientacja Medal alignment ↑↑
Rytownik(zy)
W obiegu do
Źródło(a) KM#806
Opis awersu Chinese ideograms - Top to bottom: 常平 = Sang pyong, a Department of Korean Yi Dynasty - Right to left: 通寶 = Tong bo, means currency
Pismo awersu
Legenda awersu  常 寶 通  平
Opis rewersu Mint mark at top, serial number at bottom. *開 (Kae): Kaesong Township Military Office
Pismo rewersu
Legenda rewersu  開    二
(Translation: Kaesong Township Military Office, series 2)
Krawędź Plain
Mennica
Nakład ND (1678-1752) 開 - -
ID Numisquare 3529281670
Dodatkowe informacje

Historical Context: The 2 Mun Kae (KM#806), a copper coin from Korea, was issued between 1678 and 1752 during the Joseon Dynasty. Spanning the reigns of Kings Sukjong, Gyeongjong, and Yeongjo, its introduction was a crucial monetary reform. As part of the Sangpyeong Tongbo series, this larger denomination facilitated commercial transactions and addressed currency shortages, marking a significant step in developing a robust national currency system beyond barter. It underscored the dynasty's economic stabilization efforts.

Artistry: Joseon coinage adhered to a standardized, utilitarian stylistic school, emphasizing legibility over individual engraver artistry. The obverse typically features "Sangpyeong Tongbo" (常平通寶) and "Yi Mun" (二文) in clear kai-shu script, indicating its two-mun denomination. The reverse commonly displays a character for the issuing mint (e.g., "戸" for Hojo) and a numerical value "二" (two). The design reflects a pragmatic approach to currency, ensuring widespread recognition and trust in the monetary system.

Technical/Grading: As a cast copper coin, the 2 Mun Kae's high-points, prone to wear, are the central Hanja characters on both sides. Technical strike qualities vary, with superior examples showing sharp, distinct characters and minimal casting flaws like porosity or uneven edges. The planchet should be smooth, and the central square hole cleanly formed. Preservation of character detail and surface integrity is paramount for higher grades, as copper is susceptible to wear and environmental damage.

×